World Library  
Flag as Inappropriate
Email this Article

Common-mode signal

Article Id: WHEBN0015199671
Reproduction Date:

Title: Common-mode signal  
Author: World Heritage Encyclopedia
Language: English
Subject: Isolation amplifier, Analogue filter
Publisher: World Heritage Encyclopedia

Common-mode signal

Common-mode signal is the component of an analog signal which is present with one sign on all considered conductors. In telecommunication, common-mode signal on a transmission line is known as longitudinal voltage.

In electronics where the signal is transferred by differential voltage, the common-mode signal is a half-sum of voltages

U_{cm} = \frac{U_1 + U_2}{2}

When referenced to the local common or ground, a common-mode signal appears on both lines of a two-wire cable, in-phase and with equal amplitudes. Technically, a common-mode voltage is one-half the vector sum of the voltages from each conductor of a balanced circuit to local ground or common. Such signals can arise from one or more of the following sources:

  • Radiated signals coupled equally to both lines,
  • An offset from signal common created in the driver circuit, or
  • A ground differential between the transmitting and receiving locations.

Noise induced into a cable, or transmitted from a cable usually occurs in the common mode; i.e. the same signal tends to be picked up by both conductors in a two wire cable. Likewise, RF noise transmitted from a cable tends to emanate from both conductors. Elimination of common mode signals on cables entering or leaving electronic equipment is important to ensure electromagnetic compatibility. Unless the intention is to transmit or receive radio signals, an electronic designer will generally design electronic circuits to minimise or eliminate common mode effects.

Methods of eliminating common mode signals

  • Differential amplifiers or receivers that respond only to voltage differences, e.g., those between the wires that constitute a pair. This method is particularly suited for instrumentation where signals are transmitted through DC bias.
  • An inductor where a pair of signalling wires follow the same path through the inductor. E.g. in a bifilar winding configuration such as used in Ethernet magnetics.[1] Useful for AC and DC signals, but will filter only higher frequency common mode signals.
  • A transformer, which is useful for AC signals only, and will filter any form of common mode noise, but may be used in combination with a bifilar wound coil to eliminate capacitive coupling of higher frequency common mode signals across the transformer. Used in twisted pair Ethernet.[2]

Common mode filtering may also be used to prevent egress of noise for electromagnetic compatibility purposes.

High frequency common mode signals, for example, RF noise from a computing circuit, may be blocked using a ferrite bead clamped to the outside of a cable. These are often observable on laptop computer power supplies near the jack socket, and good quality mouse or printer USB cables and HDMI cables.[3]

Switch mode power supplies include common and differential mode filtering inductors to block the switching signal noise returning into mains wiring.[4]

See also


  1. ^
  2. ^
  3. ^
  4. ^

 This article incorporates public domain material from the General Services Administration document "Federal Standard 1037C".

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.