World Library  
Flag as Inappropriate
Email this Article

Subcutaneous injection

Article Id: WHEBN0000334820
Reproduction Date:

Title: Subcutaneous injection  
Author: World Heritage Encyclopedia
Language: English
Subject: Injection (medicine), Bolus (medicine), Enfuvirtide, Venomous snake, Syrette
Collection: Dosage Forms, Pharmacology, Routes of Administration
Publisher: World Heritage Encyclopedia

Subcutaneous injection

An insulin pump with a subcutaneous injection site.

A subcutaneous injection is administered as a bolus into the subcutis,[1] the layer of skin directly below the dermis and epidermis, collectively referred to as the cutis. Subcutaneous injections are highly effective in administering vaccines and medications such as insulin, morphine, diacetylmorphine and goserelin. Subcutaneous, as opposed to intravenous, injection of recreational drugs is referred to as "skin popping". Subcutaneous administration may be abbreviated as SC, SQ, sub-cu, sub-Q, SubQ, or subcut. Subcut is the preferred abbreviation for patient safety.[2]

Subcutaneous tissue has few blood vessels and so drugs injected here are for slow, sustained rates of absorption.[3] It is slower than Intramuscular injections but still faster than intradermal injections.[3]


  • Injection sites 1
  • Equipment 2
  • Procedure 3
  • Subcutaneous insulin injections in diabetes mellitus 4
  • See also 5
  • References 6

Injection sites

Sites include,[3]

  • The outer area of the upper arm.
  • The abdomen, from the rib margin to the iliac crest and avoiding a 2 inch circle around the navel. This has the fastest rate of absorption among the sites.
  • The front of the thigh, midway to the outer side, 4 inches below the top of the thigh to 4 inches above the knee. This has a slower rate of absorption than the upper arm.
  • The upper back.
  • The upper area of the buttock, just behind the hip bone. This has the slowest rate of absorption among the sites.


A 25 to 31 gauge thick, 3/8" to 1" long needle can be used. The size is determined by the amount of subcutaneous tissue present, which is based on patient build. The 3/8" and 5/8" needles are most commonly used. Usually, no more than 1 mL of solution is given, compared to intradermal injections, where no more than 0.5 mL is usually given.[3]


Subcutaneous injections are inserted at 45 to 90 degree angles, depending on amount of subcutaneous tissue present and length of needle- a shorter, 3/8" needle is usually inserted 90 degrees and a 5/8" needle is usually inserted at 45 degrees. Medication is administered slowly, about 10 seconds/milliliter.[3]

Subcutaneous insulin injections in diabetes mellitus

A person with insulin dependent (either Type I or Type II) diabetes mellitus typically injects insulin subcutaneously.[4]

The injection should be given under the skin, into the fat layer.

See also


  1. ^ "subcutaneous injection" at Dorland's Medical Dictionary
  2. ^ "ISMP’s List of Error-Prone Abbreviations, Symbols,and Dose Designations" (PDF). 2013. Retrieved 13 May 2013. 
  3. ^ a b c d e Taylor, C. R., Lillis, C., LeMone, P., Lynn, P. (2011) Fundamentals of nursing: The art and science of nursing care. Philadelphia: Lippincott Williams & Wilkins, page 749.
  4. ^ "Insulin Administration". Diabetes Care 25 (suppl 1): s112–s115. January 2002.  
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.