World Library  
Flag as Inappropriate
Email this Article

Kirchweger condenser

Article Id: WHEBN0021728778
Reproduction Date:

Title: Kirchweger condenser  
Author: World Heritage Encyclopedia
Language: English
Subject: Bavarian B III, Oscillating cylinder steam engine, Parallel motion, Thomas Savery, Thomas Newcomen
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Kirchweger condenser

The purpose of the Kirchweger condenser (German: Kirchweger-Kondensationseinrichtung or Kirchwegersche Abdampfkondensation) was to preheat feedwater in a steam locomotive using the exhaust steam from the engine. It was invented in 1850 by Heinrich Kirchweger. A similar system was developed by Rohrbeck.

Overview

Exhaust steam was extracted from the steam chest and fed through a 100 mm diameter pipe under the locomotive to the tender. There the steam was fed directly into the feedwater, which thus heated up to boiling point. The remaining steam was allowed to escape to atmosphere through a second chimney on the tender. The quantity of steam could be regulated using a cock on the tender. The Rohrbeck system differed in detail from the Kirchweger condenser. Here steam was removed at the blast pipe and led away along the top of the boiler. It was regulated by a throttle valve on the blast pipe.

Fuel savings

Using such a system fuel savings of between 10 and 20% were possible depending on the operating conditions, in some circumstances even as much as 30% could be saved. The Lower Silesian-Märkisch Railway (Niederschlesisch-Märkische Eisenbahn) put this saving at 7.5% on its locomotives.

Contamination

However the contamination of boiler feedwater with foreign bodies was a problem. Old sources report erosion of the boiler plates which was caused by fatty acids contained in the lubricant accompanying the exhaust steam. On the other hand the formation of scale in the boiler was delayed because a proportion of the boiler scale constituents had already been left behind in the tender.

Withdrawal

On the introduction of injectors for boiler feeding the exhaust steam condensers were taken out of use from the 1860s, because injectors could only handle cold water. By about 1880 around 900 German locomotives had been fitted with condensing apparatus.

See also

References

  • R. von Helmholtz, W. Staby: Die Entwicklung der Lokomotive im Gebiete des Vereins Deutscher Eisenbahnverwaltungen, 1. Band, 1835 - 1880; Verlag von R. Oldenburg, München und Berlin, 1930
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.