Spouting Can

Not to be confused with Torricelli's equation or Torricelli point.

Torricelli's law, also known as Torricelli's theorem, is a theorem in fluid dynamics relating the speed of fluid flowing out of an opening to the height of fluid above the opening.

Torricelli's law states that the speed of efflux, v, of a fluid through a sharp-edged hole at the bottom of a tank filled to a depth h is the same as the speed that a body (in this case a drop of water) would acquire in falling freely from a height h, i.e. v = \sqrt{2gh}, where g is the acceleration due to gravity (9.81 N/kg). This last expression comes from equating the kinetic energy gained, \frac{1}{2}mv^2, with the potential energy lost, mgh , and solving for v.

The law was discovered (though not in this form) by the Italian scientist Evangelista Torricelli, in 1643. It was later shown to be a particular case of Bernoulli's principle.

Derivation

Bernoulli's principle states that:

{v^2 \over 2}+gz+{p\over\rho}=\text{constant}

where v is fluid speed, g is the gravitational acceleration (9.81 m/s^2), z is the fluid's height above a reference point, p is pressure, and ρ is density. Define the opening to be at z=Ø. At the top of the tank, p is equal to the atmospheric pressure. v can be considered 0 because the fluid surface drops in height extremely slowly compared to the speed at which fluid exits the tank. At the opening, z=Ø and p is again atmospheric pressure. Eliminating the constant and solving gives:

gz+{p_{atm}\over\rho}={v^2 \over 2}+{p_{atm}\over\rho}
\Rightarrow v^2=2gz\,
\Rightarrow v=\sqrt{2gz}

z is equivalent to the h in the first paragraph of this article, so:

v=\sqrt{2gh}

Experimental evidence

Torricelli's law can be demonstrated in the spouting can experiment, which is designed to show that in a liquid with an open surface, pressure increases with depth. It consists of a tube with three separate holes and an open surface. The three holes are blocked, then the tube is filled with water. When it is full, the holes are unblocked. The jets become more powerful, the fluid exit's velocity is greater the further down the tube they are.[1]

Ignoring viscosity and other losses, if the nozzles point vertically upward then each jet will reach the height of the surface of the liquid in the container.

References

Further reading

  • Stanley Middleman, An Introduction to Fluid Dynamics: Principles of Analysis and Design (John Wiley & Sons, 1997) ISBN 978-0-471-18209-2
  • Dennis G. Zill, A First Course in Differential Equations (2005)

See also

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.