World Library  
Flag as Inappropriate
Email this Article

Small engine

Article Id: WHEBN0031527745
Reproduction Date:

Title: Small engine  
Author: World Heritage Encyclopedia
Language: English
Subject: Oil pump (internal combustion engine), Bash valve, Internal combustion engine, Crankshaft, Propane
Collection:
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Small engine

Electrical generator, with Honda OHC engine and electric start
Rotary lawn mower, with a vertical shaft engine

A small engine is the general term for a wide range of internal combustion engines used to power lawn mowers, generators, concrete mixers and many other machines that require independent power sources.[1] Most small engines are single-cylinder, with a few V-twin units. Although much less common, there have been small Wankel (rotary) engines manufactured for use on lawn mowers and other such equipment.[2]

The engines, which may be of two or four-stroke design, are small in both physical dimensions and power output, relative to larger automobile engines. Power output ranges from less than 1 to about 15 horsepower. The smallest of all are used in handheld garden machinery, such as string trimmers and chainsaws, which may be as small as 25 cc (2 cu in) piston displacement. The most common are four-stroke air-cooled single-cylinder engines running on either petrol or diesel.[3]

Engines for small machinery that must be hand-carried, such as string trimmers and chainsaws, are usually of the two-stroke design, which is lighter for any given power output. However, two-stroke engines create a relatively large amount of air pollution and noise pollution, and so are beginning to be supplanted by four-stroke units.

Compared to modern vehicle engines, small engines are relatively simple in design. Capital cost is usually more important than fuel economy, running costs or longevity, thus encouraging simple designs.

Design

Valves are most commonly OHV actuated. An example of one of the best known and most popular designs is the Honda GX range, dating from the early 1980s.[4] The sidevalve arrangement still persists, owing to its simplicity for both manufacture and basic maintenance. A few engines, such as the Honda GC series, now use overhead cam valvegear, driven by a timing belt. This engine also uses an unusual monobloc design where the cylinder head, block, and half the crankcase share the same casting, termed 'uniblock' by Honda.

Electrical systems for these engines are usually simple and minimal, mostly to avoid the need for a battery. Many uses require the engines to be ready for immediate use, even after long standby storage and the risk of a flat battery. Most small engines are equipped with capacitor discharge ignition, that—like the magneto that preceded it—is an ignition system that does not require a battery.

Electric starting is available for small engines and is found primarily on high-feature garden machinery and larger generators particularly where there is already a complex electrical system and there may be a need for auto-starting on demand. However, a self-retracting rope-pull mechanism called a recoil starter is the predominant method of starting small engines; it does not require a battery to power a starter motor, nor an alternator to keep a battery charged. Before the invention of the recoil starter, a notched pulley was attached to the engine's flywheel; the operator would manually wind a rope around the pulley then jerk the rope to rotate the engine so that it would start. Another starting method briefly popular in the 1960s was the "impulse" or "wind-up" starter. These were operated by winding a heavy spring by means of a rotating crank handle equipped with a sprag clutch, then releasing the spring's tension by means of a lever or knob so that it would spin the engine. These were discontinued when safety problems became apparent: it was possible to leave the starter wound up and ready to start the engine unintentionally, even long after the crank was wound up, if the release were jarred.

Fuel systems are usually simple, at least for petrol engines. The fuel tank may be placed above a float-type carburettor so that gravity is adequate to bring fuel to the carburettor, avoiding the need for a fuel pump. Alternatively, the tank may be placed below a carburettor which uses engine vacuum or crankcase pressure pulsations to lift fuel into the carburetor. Float-type carburettors can only be used when the engine is reliably vertical and without excessive vibration.

Most small engines have a governor to regulate and maintain the engine speed as constantly as possible despite changing load. Some engines also have an adjustable throttle by which the operator or the machine itself can alter the engine speed. Generally, the nominal "throttle control" does not directly control the opening of the carburetor throttle, but rather increases or decreases spring tension on the governor, which in turn regulates the engine speed higher or lower.

Small engines may be configured with the crankshaft horizontal or vertical, according to the intended application. Vertical axis engines were developed for rotary lawnmowers, but the size of this large market has encouraged a supply of cheap engines and they are now used for other purposes too, such as generators.

History

Small engines date back to the early days of internal combustion engines. The first of a recognisably modern form date from the advent of motorcycles, where the engines were made by the same manufacturers.

Major manufacturers today
Major Chinese manufacturers
Past manufacturers

See also

References

  1. ^ Curt Choate; J.H. Haynes (1991). Small Engine Repair Manual.  
  2. ^ , July 1973 p. 18Popular Science"Now You Can 'Mow' with a Wankel!"
  3. ^ One-cylinder Diesel engines
  4. ^ "Honda GX160 engine". Honda. 
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 


Copyright © World Library Foundation. All rights reserved. eBooks from Project Gutenberg are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.